Mechanical and structural characterization of heat-staked parts realized by selective laser sintering of polyamide 12

Abstract Heat staking is a joining process in which thermoplastic pins are formed by heat and pressure in a form-fitting and insoluble way. This study evaluates the mechanical performance and microstructure of selective laser sintered (SLS) polyamide 12 (PA 12) components before and after heat staking, compared with conventionally turned reference specimens. The components were characterized using tensile tests, micrographs, microscopy, and micro-CT measurements. For the tests, the forces and temperatures during heat staking were varied to determine the best process parameters. Tensile tests revealed that SLS joints achieved strengths of up to 33.6 MPa, approaching the 39.9 MPa of the turned references. Microstructural analysis showed a marked reduction in porosity due to heat staking. Porosity decreased from 3.9% to 1.56% at a staking force of 300 N and from 4.29% to 0.81% at 1000 N, highlighting the beneficial effect of increased force. These results demonstrate that heat staking parameters significantly influence local densification and mechanical performance, and that, under suitable conditions, SLS components can achieve joint strengths comparable to conventionally manufactured parts. The study shows that the heat staking process parameters have a significant influence on the local microstructure and thus on the mechanical performance and provides a basis for optimizing SLS components for new heat staking applications.