In-situ characterization of the welding velocity-dependent solidification cracking dynamics in 310S stainless steel

Read full text Summarise with VIRAT
Authors: Shaowei Yang, Tamaki Ito, Guoliang Liu, Ziyang Hu, Keita Marumoto, Dan Wang, Kai Qi, Kai Tomita, Kenji Shinozaki, Motomichi Yamamoto
Cited by: 0
References: 42

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

• A novel technology is employed, which enables in-situ evaluation of solidification cracking susceptibility. • Distinct cracking modes associated with the welding velocity were elucidated. • Special inter-dendritic cracking inside single grain is observed at low velocity under high constraint. • Increased susceptibility at high velocities arises from extended mushy zones and elevated strain rates. • Solidification cracking modes are strongly governed by solidification morphology. Solidification cracking originates from strain accumulation in residual liquid films within the mushy zone. However, the influence of welding velocity on complex cracking phenomena remains insufficiently clarified. In this study, a novel system is employed, enabling in-situ characterization of solidification dynamics, cracking behavior, and temperature evolution. Distinct cracking modes associated with the welding velocity and their underlying mechanisms were elucidated. Increasing the welding velocity enhances cracking susceptibility while modifying the solidification dynamics and morphology, which in turn affect the residual liquid and strain distribution. At a low welding velocity of 1.67 mm/s under high constraint, solidification cracking manifests as interdendritic separation inside one grain, contrary to the widely reported behavior that it occurs along grain boundaries. This mode exhibits higher resistance than smooth intergranular separation. At higher welding velocities, the molten pool elongates and grains impinge at the weld center. The resulting increase in cracking susceptibility arises from the longer mushy zone and higher strain rate, rather than from reduction in the high-temperature ductility curve. Supplementary investigation confirms that cracking modes are strongly governed by solidification morphology. These findings advance the understanding of solidification cracking behavior and mechanisms, offering guidance for accurate modeling and the refinement of cracking theory.

Fields of Study & Subjects

Welding Techniques and Residual Stresses Solidification and crystal growth phenomena Metallurgical Processes and Thermodynamics

Publication details

Journal / source
Materials & Design
Volume
265
Pages
115931–115931
Publication date
27 March 2026
Language
EN