Numerical analysis and engineering application of bolt support technology for controlling coal body sliding

Read full text Summarise with VIRAT
Authors: Chengwu Wang, Shuangwen Ma
Cited by: 0
References: 34

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

With increasing coal mining depth, coal bumps-disasters that severely compromise mine safety-have garnered growing attention in the mining industry. Among these, coal bump sliding-type coal bumps cause significant structural damage and pose serious safety hazards. Analysis of damage patterns indicates that such sliding typically originates from insufficient strength at the coal-rock interface. To address this issue, bolt support technology has been proposed to enhance the reinforcing capacity of roadway support systems at this critical interface. The arrangement angle of the bolts significantly affects the reinforcement of the interface. This study uses ABAQUS software to simulate and analyze the stress-strain and bearing characteristics of bolts at support angles of 30°, 45°, 60°, and 90°. The simulation results show that at support angles of 30° and 45°, the bolt fails primarily due to tensile forces, while at 60° and 90°, failure is mainly caused by shear forces. The higher load-carrying capacity of the bolt under tensile damage, compared to shear damage, indicates stronger reinforcement of the interfaces. The research findings were implemented in the return airway of a working face at a coal mine. Field observations during roadway excavation in the test section revealed relatively minimal roof separation. Compared to the conventional support system, the cumulative sidewall displacement was reduced by 28.6% during excavation and by 51.9% after mining commenced, while roof separation remained consistently low. These results confirm that the proposed bolt support technology significantly improves control of the surrounding rock mass in roadways.

Fields of Study & Subjects

Geomechanics and Mining Engineering Rock Mechanics and Modeling Geotechnical and Mining Engineering

Publication details

Journal / source
Scientific Reports
Volume
16
Issue
1
Pages
15566
Publication date
31 March 2026
Language
EN