Definition of the feed influence during the FSP process of steel surfaces on hardening by alloying with WC-Co tool particles. Modeling and experiment

View at publisher Summarise with VIRAT
Authors: Viktor P. Kuznetsov, Igor A. Vorontsov, Andrey S. Skorobogatov
Cited by: 0
References: 8

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

The article presents an analytical model and performed calculations of the temperature in the contact zone of the tool during friction-stir processing of AISI 420 steel, depending on the thermal properties of the materials and technological parameters. It is shown that feed rate reduction from 100 mm/min to 50 mm/min increases the maximum temperature in the contact zone of the rotating tool from 1250 to 1430 °C and extends holding time at the austenization temperature from 7.5 to 32.3 sec. The experimental studies of the process indirectly confirm the results of modeling based on the thickness of the hardened layer. It is shown that when the feed rate decreases from 100 mm/min to 50 mm/min, the thickness of the hardened layer increases from 850 microns to 1500 microns.

Fields of Study & Subjects

Advanced Welding Techniques Analysis Advanced machining processes and optimization Surface Treatment and Coatings

Publication details

Journal / source
AIP conference proceedings
Volume
3405
Pages
230001–230001
Publication date
1 January 2026
Language
EN