Enhancing tribological performance of 40Cr substrates through laser-cladded TiC-graded composite coatings

View at publisher Summarise with VIRAT
Authors: H. Liang, Jiawei Cao, Jinhua Chen, Guihua Hang
Cited by: 0
References: 33

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

To address wear degradation in 40Cr alloy steel, this study employs laser additive manufacturing to fabricate TiC-reinforced coatings on 40Cr surfaces. Using 12CrNi2 alloy steel powder as the metal matrix, both gradient-reinforced and uniformly reinforced coatings are produced and systematically compared. The influence of TiC on wear resistance is evaluated through detailed analyses of phase composition and microstructure using X-ray diffraction, optical microscopy, and scanning electron microscopy. Microhardness and wear performance under varying loads are assessed using a micro-Vickers hardness tester and friction-and-wear tester, respectively. Results indicate a strong metallurgical bond between coating and substrate, with TiC and ferrite as the dominant phases. TiC nanoparticles are uniformly distributed within the coatings, showing enhanced concentration in gradient-reinforced coating, which exhibits dendritic and equiaxed crystal structures. The average microhardness of the gradient-reinforced coating reaches 861 HV, exceeding the 803 HV of the uniformly reinforced coating. Wear tests under 50 N and 100 N loads demonstrate that the gradient-reinforced coating experiences significantly lower material loss compared to uniformly reinforced coating and 40Cr substrate. Overall, the gradient-reinforced coating displays superior wear resistance, roughly double that of the bare 40Cr alloy steel, highlighting the effectiveness of TiC reinforcement and gradient distribution in enhancing tribological performance.

Fields of Study & Subjects

Surface Treatment and Coatings Additive Manufacturing Materials and Processes Metal Alloys Wear and Properties

Publication details

Journal / source
Australian Journal of Mechanical Engineering
Pages
1–13
Publication date
22 March 2026
Language
EN