Analysis and modeling of tungsten emission and net erosion in the DIII-D divertor using updated atomic data

Abstract Tungsten (W) is one of the leading candidate materials for plasma-facing components. However, its main drawback is its high radiative efficiency; if W penetrates the plasma, it can lead to core degradation or even collapse. Since eroded tungsten tends to ionize in the sheath and redeposit promptly, the net erosion flux that escapes prompt redeposition can differ significantly from the gross erosion. This work presents a modeling framework to estimate net erosion and photon emission from W coatings exposed to the lower divertor of DIII-D using the DiMES material exposure probe. The approach couples RustBCA for sputtering yields with a Monte Carlo transport code (LPTMC) that models redeposition and W emission. Computation is carried out with new atomic data, based on R-matrix and Mons calculations, leading to lower ionization probabilities and a twofold increase in net erosion estimates compared to calculations done with OPEN-ADAS atomic data. The model results are benchmarked against experimental measurements, showing quantitative agreement for erosion, although the trends in W emission are reproduced only qualitatively. The model is also used to assess whether W II emission can serve as a direct measurement of the net erosion of W in the lower divertor of DIII-D. Simulations show that this is not valid if the electron pressure is above ∼ 120 Pa or if the toroidal length of the eroded material is smaller than the parallel-to-B distance traveled by impurity ions before steady-state conditions are reached. Finally, simulations suggest that when W is sputtered by carbon ions with high impact energies ( ≳ 300 eV) in DIII-D, W net erosion scales with W gross erosion and can be numerically approximated using W I flux alone as input.