Study on friction characteristics of rough surfaces in bipolar plate stamping forming based on the differential method

View at publisher Summarise with VIRAT
Authors: Yu Liu, Xiaofeng Zhang, Jingzhou Qin, Jialiang Qi, Shengfang Zhang
Cited by: 0
References: 17

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

Abstract Friction during bipolar plate stamping induces uneven thickness distribution and stress concentration, which severely degrades fuel cell performance. A differential-based mechanical contact model for rough surface displacement was developed. The model analyzes displacement variations in both horizontal and vertical directions under applied loads, incorporating W-M fractal theory to characterize surface topography. Explicit dynamic finite element methods were employed to establish region-specific stamping friction models for critical groove features, including the flange, upper fillet, straight edge, lower fillet, and groove bottom, accounting for their distinct contact behaviors. The derived region-dependent friction coefficients were implemented in a global stamping model to evaluate their influence on groove thickness distribution and stress distribution. This approach enables cross-scale correlation analysis, bridging microscopic surface displacement with macroscopic frictional behavior. The determined friction coefficients measure 0.10 (flange), 0.12 (upper fillet), 0.14 (straight edge), 0.16 (lower fillet), and 0.13 (groove bottom). Implementation of these segmented friction coefficients resulted in periodic fluctuations in thickness (minimum: 0.070 mm) and stress (peak: 827 MPa), with significant regional variations observed. Experimental validation confirmed good agreement with simulation results, showing consistent trends. The maximum discrepancy in thickness reduction (2.6%) occurred at the fillet region. This study provides important evidence for improving the quality of bipolar plate stamping.

Fields of Study & Subjects

Metal Forming Simulation Techniques Tribology and Lubrication Engineering Contact Mechanics and Variational Inequalities

Publication details

Journal / source
Surface Topography Metrology and Properties
Volume
14
Issue
2
Pages
025002–025002
Publication date
26 March 2026
Language
EN