Oil-impregnation parameters influence the wear resistance of polyamide components

Read full text Summarise with VIRAT
Authors: V S Bychkovsky, N. G. Filippenko, A. B. Livshits, Чумбадзе Тамара Темуриевна
Cited by: 0
References: 15

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

This study investigates the abrasive wear rate of a polyamide component as a function of its temperature and hexane content in the process fluid used to impregnate its surface layer with oil. We employed an abrasive wear testing method described in GOST 11012–2017, “Plastics. Method of test for resistance to abrasion”. The experimental setup involved a plane–disc abrasion scheme with a high disc rotation speed of 610 rpm. Test samples (Ø10 × 10 mm) were manufactured using polyamide grade PA6. The abrasive material was grade 6 CK19XW sandpaper, according to GOST 344–79. The research findings indicated that the abrasive wear rate of the PA6 polyamide samples ranged from 0.016 to 0.029 mm/min. This study also established relationships between the depth of abrasive wear (up to 2 mm) and the duration of wear for both non-impregnated and oil-impregnated samples under various processing conditions. The results confirm that the temperature of the polyamide sample and the hexane content in the low-viscosity process fluid during oil impregnation influence the abrasive wear rate, with a maximum improvement in wear resistance of 54.5% achieved at a sample temperature of 75°C and a hexane content of 40%. These findings are necessary for developing engineering support for oil impregnation to a specified depth of the surface layer in polyamide components used in friction units that operate under conditions of abrasive wear and high load.

Fields of Study & Subjects

Tribology and Wear Analysis Metal Alloys Wear and Properties Tribology and Lubrication Engineering

Publication details

Journal / source
iPolytech Journal
Volume
30
Issue
1
Pages
10–18
Publication date
29 March 2026
Language
EN