Formulas for the first two frequencies of natural oscillations of a flat truss

Read full text Summarise with VIRAT
Authors: M. N. Kirsanov, О. V. Gribova
Cited by: 0
References: 17

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

Introduction. Calculation of the natural oscillation frequency is the basis of the study of structural dynamics and is usually based on numerical methods. In cases where the structure is statically determinate and has a periodic structure, analytical solutions are also possible for estimating the first natural frequency. The most well-known here are the Rayleigh method for estimating the frequency from above and the Dunkerley method, which gives an approximate estimate from below. In this paper, simple analytical estimates are derived for the dependences of the first oscillation frequencies of a flat truss on the number of panels and the parameters of the structure. Materials and methods. A statically determinate beam truss has a rise in the middle part. A simplified version of the Dunkerley method is used for the analytical calculation of the first natural oscillation frequency. The forces in the rods included in the formula are calculated in symbolic form by cutting out nodes using standard operators of the Maple computer mathematics system. The Maxwell – Mohr formula is used to determine the rigidity of the structure. It is assumed that the truss mass is uniformly distributed over all its nodes. The induction method is used to generalize the sequence of individual solutions for trusses of different orders to an arbitrary number of panels. The formula for the second natural frequency is obtained by the three-point collocation method based on the condition of similarity of the curve of the first frequency dependence on the number of panels. Results. Formulas for the first two frequencies of natural oscillations of the truss are derived. Analytical solutions are compared with numerical ones obtained for the entire frequency spectrum. It is shown that with an increase in the number of panels, the accuracy of the analytical solution increases. Conclusions. The analytical method for estimating the first and second frequencies is applicable to solving problems on regular structures. The advantage of the method is that its accuracy is independent of the order of regularity of the structure. The simple form of the result allows it to be used to select the optimal parameters of the object without the use of labor-intensive computer calculations.

Fields of Study & Subjects

Vibration and Dynamic Analysis Structural Engineering and Vibration Analysis Structural Analysis and Optimization

Publication details

Journal / source
Vestnik MGSU
Volume
21
Issue
2
Pages
186–194
Publication date
26 February 2026
Language
EN