Effect of the Electrocorundum Particles Type on Infiltration and Wear Pates of Composite with Manganese Cast Steel Matrix

Read full text Summarise with VIRAT
Authors: Daniel Medyński
Cited by: 0

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

The subject of the research were castings made of GX120Mn13 manganese steel, zone-reinforced with electrocorundum. The study determined the effect of the type of electrocorundum (ordinary Al₂O₃ and zirconium Al₂O₃+ZrO₂) on the degree of infiltration and abrasive wear of the reinforced areas of the castings. Computed tomography showed that the use of zirconium electrocorundum for strengthening, compared to ordinary corundum, resulted in a higher degree of infiltration of the reinforced zones of the castings and lower porosity in these areas. This was probably due to the better wettability of Al₂O₃+ZrO₂ particles by the liquid alloy, caused by the zirconium content in the electrocorundum. Lower porosity of the reinforced zones resulted in a lower abrasive wear rate of the samples, but the differences were small. Therefore, the resulting defects did not have a significant impact on the wear rate of the reinforced zones of the casting. The key factor in this respect was the introduction of electrocorundum into cast steel, which, regardless of its type, increased resistance to abrasive wear by approximately 70%. This is very important for the operational durability of this type of castings, taking into account the economic aspect.

Fields of Study & Subjects

Metal Alloys Wear and Properties Erosion and Abrasive Machining Aluminum Alloys Composites Properties

Publication details

Journal / source
Archives of Foundry Engineering
Pages
93–96
Publication date
30 March 2026
Language
PL