The evolution of the concept of a “small” aircraft and the development of its design

Read full text Summarise with VIRAT
Authors: Aleksandr Bobkov, T. A. Mitashova
Cited by: 0
References: 5

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

This study analyzes the design features of small, aircraft-type unmanned aerial vehicles. The first stage of the study examined the chronology of the evolution of the concept of “small”. It was shown that this concept should be understood as a combination of two factors: small size and low flight speeds. Because of this, the boundary layer flow occurs in a laminar-turbulent transition regime. Due to boundary layer instability, a “laminar bubble” forms above the wing, reducing the lift properties of the vehicle. Reynolds numbers in the range of Re = 105…106 were proposed as an aerodynamic criterion for smallness. At speeds of 70–150 km/h, the mean aerodynamic chord size is in the range of baverage = 0.1–0.9 m. The second stage analyzed the influence of the “square-cube” law on the energy efficiency of the vehicle during the miniaturization of its design. According to this law, the specific wing loading and the (weight)1.5/power ratio are reduced by the magnitude of the reduction factor for the linear dimensions of the aircraft. This is interpreted in the article as a reduction in the efficiency of the aircraft, which converts the kinetic energy of the airflow into lift. When transporting a unit of weight over a unit of distance, a small aircraft consumes several times more fuel than a full-size aircraft. A potential way to increase energy efficiency is to reduce or eliminate the trim losses of lift. This reduction is achieved by reducing the area of the rear-mounted horizontal tail, and the elimination of this loss is achieved by replacing the standard aerodynamic configuration with alternatives: canard or tailless configurations. These configurations do not use a rear-mounted horizontal tail, which generates negative lift, requiring additional energy to compensate. At the 3rd stage of the study, recommendations were formulated for the developers of the considered class of devices: 1) small-sized devices have a naturally low aerodynamic and energy efficiency, increasing which to the level of full-size devices is practically impossible; 2) improving aerodynamics is possible through the use of special profiles, morphing wing technology and boundary layer control methods; 3) increasing the duration and range of flight is possible due to the reduction of balancing losses of lift, using a beam tail in a normal configuration or using alternative aerodynamic configurations; 4) the article presents a block diagram of the iterative process for determining the wing area, the value of which will satisfy the conditions of the balance of forces and moments for various values of the ratio of the wing and horizontal tail areas.

Fields of Study & Subjects

Advanced Aircraft Design and Technologies Aerospace and Aviation Technology Fluid dynamics and aerodynamics studies

Publication details

Journal / source
Siberian Aerospace Journal
Volume
27
Issue
1
Pages
96–107
Publication date
26 March 2026
Language
EN