Numerical Study on the Aerodynamic Performance of a UAV S-Shaped Inlet with Grilles

This investigation designs grilles of two configurations inside an S-shaped inlet for UAVs. The present work numerically investigates the effects of the configurations, numbers, diameters, and lengths of the grilles on the inlet aerodynamic performance under different flight conditions, such as airflow Mach number, angle of attack, and sideslip angle. The influences of the baseline configuration, Configuration 1, and Configuration 2 on the aerodynamic performance of the inlet are systematically compared. The numerical results show that after installing the grilles, the total pressure recovery decreases by an average of 5.42% for Configuration 1 and 3.46% for Configuration 2. In terms of the absolute circumferential total pressure distortion, which decreases by 1.26% for Configuration 1 and 2.34% for Configuration 2, the swirl distortion index of Configuration 2 approaches zero. It is found that a large sideslip angle significantly degrades the inlet performance, and Configuration 1 experiences the maximum decline of approximately 0.0124 in the total pressure recovery. Based on the optimized design of Configuration 1, the optimal parameters are determined as 5 grille rows, a grille diameter of 4 mm, and a grille length of 6 mm. This configuration achieves an optimal balance between flow regulation and resistance suppression, with a maximum total pressure recovery of 0.9884 and the absolute circumferential total pressure distortion controlled below 0.015. This study clarifies the optimization direction of key parameters for grilles and provides a theoretical basis and technical reference for the design of UAV S-shaped inlet and grille integrations.