The Influence of La and Ce on Thermal Conductivity of Magnesium Alloys

With the development of science and technology, heat dissipation has become a bottleneck problem restricting the development of fields such as transportation, machinery, electronics, and aerospace. Aiming to resolve the bottleneck problem of low thermal conductivity in traditional commercial magnesium alloys, this paper designed alloy compositions to investigate the effects of the solid solubility of La and Ce, and the size, morphology, distribution, and volume fraction of the second phase in the microstructure of magnesium alloys during the heat dissipation performance of the Mg-RE binary system and the Mg-Mn-La(Ce) system. The research shows that through CAFE simulation calculations, regulation can be achieved via the following methods: increasing the average nucleation undercooling, which leads to larger grain sizes; reducing the nucleation density, which results in larger grain sizes; and increasing the standard deviation of the average nucleation undercooling, which reduces the area of small grains while increasing the area of large grains. The thermal conductivity of both as-cast and solid-solution Mg-La (Ce) binary alloys gradually decreases with the increase in the added elements. However, after solution treatment, the thermal conductivity of the Mg-La (Ce) binary alloys is higher than that of the as-cast alloys. The addition of the Ce element helps refine the as-cast microstructure of the Mg-0.5Mn alloy. With the increase in Ce addition, the volume fraction of the Mg12Ce phase also increases. The thermal conductivity of the as-cast Mg-0.5Mn-xCe alloy gradually increases with rising temperature. Meanwhile, at room temperature, the thermal conductivity of the as-cast Mg-0.5Mn alloy gradually decreases with the increase in Ce addition, and the rate of decline gradually slows down due to the precipitation of the Mg12Ce phase.