Basement-Controlled Urban Fracturing: Evidence from Las Pilas, Zacatecas, Mexico

The formation of fractures in urban areas is typically related to construction processes, natural ground settlement, and material quality. In valleys, the distribution of ground fissures is associated with aquifer overexploitation and basement faulting. However, where the soil layer is only a few meters thick or absent, the influence of basement structures remains poorly understood. We hypothesize that urban fractures develop parallel to major basement faults. To test this, we applied a simple structural geology technique to systematically measure extension axes, from street fractures, throughout the town of Las Pilas. These axis orientations were then compared with those calculated for normal faults of Las Pilas Complex. Street fractures are generally about 1 cm thick, with lengths ranging from 0.51 to 1 m and occasionally reaching up to 3 m. They occur within streets 2 to 4 m wide, typically appearing as a single fracture within a 1–2 m wide fracture zone. Based on these characteristics, the fractures do not represent a significant hazard. Measurement results indicate that urban fractures primarily extend in an NE-SW direction. This is consistent with the orientation of the minimum principal stress axis (3) of the regional San Luis-Tepehuanes fault system, thereby supporting our hypothesis.