Design of Axial Profiling and Investigation of the Influence of Pocket Position on Lubricant Flow in Planetary Journal Bearings in Applications with Low Sliding Speeds and High Loads

Read full text Summarise with VIRAT
Authors: Sören Henniger, Jan Zwinge, Gino Donato Grossi, Thomas Hagemann, Hubert Schwarze
Cited by: 0
References: 20

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

The application of plain bearings has become very famous in planetary gear stages in recent years. To improve load-carrying capacity, this study investigates a design method for axial profiling in which a sixth-order polynomial is iteratively derived from the curve of local minimum film thickness for each axial grid position. Two load cases with specific bearing loads of 12.0 MPa and 6.0 MPa at 0.5 m/s are considered for profile design. Calculation results and computational effort of strategies assuming rigid or elastic geometries during the optimization are compared. Results indicate that the consideration of deformation is already necessary in the design phase and a maximization of minimum film thickness leads to much higher load-carrying capacity than the minimization of the maximum film pressure. Furthermore, the impact of the lube oil pocket position on oil flow rate is experimentally and theoretically investigated to identify the optimization potential of this parameter. Results show that the oil flow varies by the factor of three if the lube oil pocket is shifted incrementally over an angular span of 180° outside the load zone. The results and possible extensions are critically discussed under the consideration of practically relevant restrictions in mechanically highly loaded planetary gearboxes.

Fields of Study & Subjects

Tribology and Lubrication Engineering Gear and Bearing Dynamics Analysis Lubricants and Their Additives

Publication details

Journal / source
Lubricants
Volume
14
Issue
4
Pages
144–144
Publication date
31 March 2026
Language
EN