Automated Flushing System for Post-Processing in Microfluidic Device Fabrication

Post-processing remains a major bottleneck in the fabrication of microfluidic devices using Digital Light Processing Stereolithography (DLP-SLA) 3D printing, where unpolymerized resin trapped within internal structures must be removed without damaging delicate features such as thin membranes, valves, and pumps. Manual flushing is slow, inconsistent, and prone to structural failure, especially as device complexity and port counts increase. Here, we present the first fully automated flushing system for DLP-SLA microfluidic devices, enabled by a standardized chip-to-chip (C2C) interconnect architecture and an electronically controlled pneumatic routing platform. A reusable 32-port flushing interface chip provides alignment, sealing, and modular coupling to arbitrary device chips through integrated microgaskets, while a network of electronic pressure controllers, differential pressure sensors, and multi-port rotary valves enable precise, programmable application of pressure, vacuum, and solvent conditions. We introduce a fluidic-circuit model of the system that relates applied pressure to the pressure drop across device structures and experimentally validate this model using channels with varying fluidic resistances. Using this platform, we demonstrate robust flushing of both passive (straight and serpentine channels) and active (valves, pumps) microfluidic elements, as well as application-specific devices including mixers and concentration-gradient generators. Our system eliminates manual handling, improves valve membrane survival, and provides repeatable flushing across a broad range of device geometries. This work establishes a scalable foundation for automated post-processing in 3D-printed microfluidics and significantly advances the practicality of DLP-SLA fabrication for complex, multi-layered microfluidic devices.