Pollution Flashover Characteristics of Hydrophilic/Hydrophobic Alternating Surfaces for Insulator Hybridization

With the growing trend toward insulator hybridization, higher requirements are imposed on the synergistic improvement of interfacial durability and pollution flashover performance. Machining annular grooves at the green-body stage and embedding silicone rubber enables the construction of an embedded structure with improved durability, forming hydrophilic/hydrophobic alternating surfaces. However, the outdoor insulation characteristics of such hybrid surfaces remain insufficiently investigated, and their engineering feasibility requires further validation. In this study, a series of hydrophilic/hydrophobic alternating surfaces were fabricated, and artificial pollution tests were conducted. The results show that the AC pollution flashover voltage exhibits a saturated increasing trend as the hydrophobic interfaces become more dispersed. When twenty 4 mm wide hydrophobic interfaces were distributed along a 16 cm creepage distance, the flashover voltage was 12.4% higher than that of a fully hydrophobic surface. These results indicate that appropriate design of hydrophobic interface distribution can achieve excellent pollution flashover performance even at relatively low hydrophobic coverage (≤50%). High-speed imaging combined with infrared thermography reveals the discharge mechanism governed by hydrophobic interface distribution from an electro-thermal coupling perspective. The coexistence of multiple dry bands induced by discrete hydrophobic interfaces is identified as the key factor enhancing flashover withstand capability. A static pollution flashover model was established to quantitatively estimate the AC flashover voltage, confirming the external insulation feasibility of the embedded hybrid concept.