Reduced-Switch Active Power Filter with Modified One-Cycle Control for Non-Ideal Voltage Conditions

With the evolution of new power systems, harmonic sources in distribution networks have become increasingly dispersed, thus requiring lower-cost harmonic mitigation devices suitable for large-scale deployment. With its simple control architecture, the one-cycle controlled active power filter (APF) is better adapted to meet the aforementioned requirements. That said, under non-ideal voltage conditions like voltage distortion or unbalance, the compensating target current of the APF that relies on traditional one-cycle control (OCC) will undergo distortion as well, resulting in a substantial reduction in the compensation effect. This paper introduces a modified OCC method based on a positive-sequence filter, which allows for the control of a reduced-switch three-phase APF. This control method eliminates the negative sequence and harmonic components in the target current of the APF, and makes the compensated current maintain a good sinusoidal waveform. A one-cycle control equation applied to the reduced-switch APF was derived. The modified one-cycle control method allows the active filter to retain a favorable compensation effect when operating under non-ideal voltage conditions. Meanwhile, it preserves the inherent advantages of traditional one-cycle control, including the elimination of a phase-locked loop (PLL), a fixed switching frequency, and a straightforward control structure. Finally, an APF simulation model and a dSPACE-based APF experimental circuit were built to verify the proposed control method. In simulation, with the adoption of the modified OCC, the THD of the current was reduced from 8.25% before improvement to 3.79% after improvement. In experiments, according to the spectrum analysis function of the oscilloscope, the third-order current harmonic caused by voltage distortion was decreased from 500 mA to 100 mA, representing a reduction of 80%. Both simulation and experimental results verify that the proposed modified one-cycle control method can effectively solve the problem that control performance is susceptible to voltage quality.