Twist-Tuned Bilayer Metasurface for 3T MRI

Read full text Summarise with VIRAT
Authors: Ingrid Torres, Raquel Rodriguez, Robert W. Laird, Angela Marie Richmond Laird, Alex Krasnok
Cited by: 0
References: 18

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

Magnetic resonance imaging (MRI) can see deep inside the body without ionizing radiation, but image quality depends strongly on how well the radio-frequency field is controlled. Passive resonant pads and metasurfaces can help, yet they often lose their tuning when they are placed next to water-rich tissue or tissue-like materials. Here we show a simple way to bring such a device back into tune. We built a bilayer metasurface made of two aluminum wire arrays. One layer can rotate relative to the other, and the gap between the two layers can also be adjusted. Bench measurements show that adding a controlled water load shifts the resonance to lower frequency by about \SIrange{4.2}{11.4}{\mega\hertz}. Rotating the layers shifts it back by about \SIrange{13.2}{14.9}{\mega\hertz}, which is much stronger than changing the gap alone. One loaded setting lands essentially at the proton frequency used in \SI{3}{\tesla} MRI. In a proof-of-concept scan on a clinical \SI{3}{\tesla} system, the metasurface made internal features in a structured pineapple phantom easier to see than in a substrate-only control. These results show that a passive MRI metasurface can be tuned after fabrication and retuned under load using geometry alone, opening a practical route to simple adjustable RF accessories for MRI.

Fields of Study & Subjects

Metamaterials and Metasurfaces Applications Advanced MRI Techniques and Applications Advanced Antenna and Metasurface Technologies

Publication details

Journal / source
arXiv (Cornell University)
Publication date
23 March 2026
Language
EN
Document type
Preprint