Comment on egusphere-2025-5566

Abstract. The marine science community requires accurate, cost-effective, and reliable pH sensors capable of long-term, stable operations in-situ from coastal to deep-sea environments. Spectrophotometric pH sensors based on lab-on-chip (LOC) technology have been shown to offer long-term accuracy that can sample every 10 minutes. However, for applications where higher-frequency measurements are important, this maximum sample rate may be limiting, in addition to the power requirements needed to operate the sensor. In contrast, commercially available pH optodes (PyroScience GmbH) are relatively inexpensive, consume little power and have a small form factor, but with intense use the pH sensitive membrane can photo-oxidise, causing signal drift. The combination of LOC and optode technologies, however, can be used to provide long-term, high-frequency and high-stability in-situ pH data, but protocols to correct for sensor drift need to be developed and evaluated. To examine sensor drift and develop protocols to account for it, we suspended two LOC pH sensors with two pH optodes at 0.5 m depth from a floating pontoon within a harbour in Southampton, UK for six months (June–December 2023). This is a highly dynamic tidal environment with substantial biofouling. The optode (AquapHOx-L-pH, PyroScience GmbH) and an independent pH sensor (Deep SeapHOx V2, Sea-Bird Scientific) measured at a high frequency (e.g., ≤5 min) alongside a LOC pH sensor measuring at a lower frequency (e.g., ≤2 hr). Triplicate lab validated co-samples were collected each week, in addition to dedicated sensors monitoring the temperature, salinity, dissolved oxygen and tidal height. We find good agreement i.e., mean ∆pH = -0.022 ± 0.023 (3,182 data points in common) pH units between the SeapHOx and LOC sensors, in addition to individual field accuracies of