Study of Stable and Efficient Photoelectrode for Photo-Electrochemical Splitting of Water

View at publisher Summarise with VIRAT
Authors: Hariom Jaimini, Lal Yadav, R. C. Meena, S. L. Meena
Cited by: 0
References: 37

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

One method that shows promise for producing hydrogen more easily and sustainably is photoelectrochemical (PEC) water splitting. PEC-based hydrogen generation solves the issue of solar persistency and offers a sustainable and environmentally friendly energy source. Despite significant attempts over the past few decades, no solar water splitting material has yet to meet the requirements of high efficiency, long-term stability, and affordability. The photoelectrode materials used in PEC must have band edge potentials at the surfaces, long-term stability against corrosion in the aqueous electrolyte, and enough voltage upon irradiation to split water. The oxygen and hydrogen evolution reaction are required for the charge transfer from the semiconductor's surface to the electrolyte. The most promising semiconductor materials are photocatalysts like TiO2, WO3, Fe2O3, Cu2O, etc., because of their appropriate band gap and valance band structure. However, charge separation and conveyance are the main issues with PEC water splitting. The efficiency of the PEC process is increased by a number of techniques, including morphological control, defect introduction, heterojunction construction, and co-catalyst loading. The energy gap of n-type cuprous oxide (Cu2O), which absorbs visible light up to a wavelength of 600 nm, makes it a suitable material for photocatalysis. Cu2O's thickness is important as a photoelectrode since an incorrect thickness could deteriorate its photocatalytic qualities. By adjusting the Cu2O thickness, this work sought to improve the photocatalytic capabilities of Cu2O electrodeposited on fluorine-doped tin oxide (FTO), or Cu2O/FTO. Cu2O/FTO electrochemical deposition allowed for the control of Cu2O thickness by varying the deposition duration. Cu2O's morphology altered from a leaf-like shape to an irregular facet shape with highly dense coverage when the deposition duration was varied from 8 to 40 minutes. The average thickness also rose from 450 to 1050 nm. Cu2O/FTO achieved the highest photocurrent (150 and 158 µA under irradiation of 450 and 570 nm, respectively) at a thickness of 900 nm because of its extremely dense morphology and high absorption. Additionally, the charge diffusion was still good at a thickness of 900 nm. Further, the increase of Cu2O film thickness higher than 900 nm caused low photocatalytic properties even though the morphology was highly dense, and the absorption was the highest. This state might result from Cu2O's comparatively too high resistance, which led to inadequate charge dispersion.

Fields of Study & Subjects

Advanced Photocatalysis Techniques Copper-based nanomaterials and applications TiO2 Photocatalysis and Solar Cells

Publication details

Journal / source
International Journal of Global Research Innovations & Technology (IJGRIT).
Volume
04
Issue
01
Pages
82–92
Publication date
30 March 2026
Language
EN