Combined electrostatic precipitation-photocatalytic oxidation technology for simultaneous abatement of indoor PM and VOCs : experimental analysis and multiphysics modelling

Indoor air quality (IAQ) is increasingly recognised as a major public health concern, as people spend most of their time indoors and are therefore continuously exposed to pollutants present in indoor environments. Among indoor contaminants, particulate matter (PM) and volatile organic compounds (VOCs) are of particular concern due to their health impacts and prevalence in buildings. While air purification technologies can reduce exposure, most systems target only one type of pollutant, i.e. particulate or gaseous. This dissertation explores the integration of electrostatic precipitation (ESP) and photocatalytic oxidation (PCO) into a single device to enable simultaneous removal of PM and VOCs. It is hypothesised that incorporating PCO into the collector section of a two-stage ESP reactor enables simultaneous removal and may reduce the need for cleaning the ESP by degrading deposited particles. A combined ESP-PCO reactor was developed with a photocatalytic coating immobilised on the collector plates and UV lamps positioned between them, alongside multiphysics models describing the underlying processes. First, the standalone ESP functionality was investigated to determine total and fractional particle collection efficiencies, the influence of operating conditions, and ozone emission. Next, the photocatalytic coating was examined independently for photocatalytic VOC (acetaldehyde) removal, comparing metallic substrates and studying the effects of coating layers, inlet concentration, and relative humidity. Photocatalytic soot degradation experiments were also performed to evaluate removal of deposited PM. Subsequently, acetaldehyde removal was studied in the full two-stage ESP-PCO reactor to assess PCO and ESP functionality in terms of clean air delivery rate (CADR) and single-pass removal efficiency (SPRE). Activation of the ionisation section resulted in acetaldehyde removal comparable to photocatalytic removal, while combining ESP and PCO yielded the highest removal observed, although synergistic effects were not clearly identified. Finally, multiphysics models for ESP and PCO were developed to describe air flow, electric field, ion transport, particle charging and motion, acetaldehyde transport, radiation distribution, and photocatalytic kinetics. The models were verified against experiments and provide insight into the influence of plate spacing, irradiance distribution, and electric field effects while identifying opportunities for performance optimisation. Overall, this dissertation demonstrates the feasibility of integrating photocatalytic oxidation into a two-stage electrostatic precipitator for indoor air purification, showing that the combined system can remove both PM and VOCs and has the potential to reduce particle accumulation. However, the results highlight design, material, and modelling challenges requiring further development.