Influence of Interface Bonding Condition and Base Layer Elastic Modulus on Asphalt Pavement Structure Mechanical Response to Non-Uniform Loads

Read full text Summarise with VIRAT
Authors: Lana Elabbas Abdelhaliem Babiker, Xin Xiang Jiang, Canyang Cui, Yangchen Lu, Mian Zhang, Yang Xue, Yanjun Qiu
Cited by: 0
References: 62

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

This study established the ratio of the base layer’s elastic modulus to that of the surface layer Rm as a key variable to systematically investigate how the base layer’s elastic modulus influences the mechanical response and service life of flexible pavement. A three-dimensional finite element model of a three-layer pavement system was analysed, using EverStressFE, with a constant surface layer modulus and a variable base layer modulus. The analysis included two important interfacial bonding conditions: full bonding and full slip. It also considered that the actual wheel loads are not uniform but rather follow concave and convex distribution patterns. The mechanical responses, including deflection at the top of the asphalt layer, tensile strain at the bottom of the asphalt layer εxx, and vertical compressive strain at the top of the subgrade εzz, were quantified to predict fatigue life (for cracking) and rutting life (for permanent deformation). The results indicated that the maximum deflection reached 0.53 mm under a full slip condition with a convex load distribution at Rm = 0.75. Critical tensile strains at the bottom of the asphalt layer were most severe under full slip with a convex load, reaching 348 × 10−6, while the fully bonded, concave case resulted in a much lower value of 83 × 10−6. Similarly, the maximum vertical compressive strain on the subgrade was 365 × 10−6 for the fully slipped, convex case compared to 250 × 10−6 for the fully bonded, concave case. A lower Rm value under full slip with a concave load distribution significantly reduced the pavement lifespan, with predicted fatigue life decreasing by over 60% and rutting life by nearly 45% compared to the fully bonded case. On the other hand, a convex load distribution greatly increased the pavement’s bearing capacity by raising the critical strain thresholds and lengthening the expected service life. These findings underscore the paramount importance of interface bonding and load distribution patterns, suggesting that they can outweigh the influence of the base layer’s modulus alone on pavement design.

Fields of Study & Subjects

Asphalt Pavement Performance Evaluation Geotechnical and construction materials studies Railway Engineering and Dynamics

Publication details

Journal / source
The Baltic Journal of Road and Bridge Engineering
Volume
21
Issue
1
Pages
125–150
Publication date
26 March 2026
Language
EN