Study and modeling of chlorine decay in a drinkable water distribution system

Read full text Summarise with VIRAT
Authors: Scott Martínez Vila
Cited by: 0

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

Ensuring adequate chlorine concentration throughout a drinking water distribution system is essential to guarantee water quality and public health. Since continuous measurement of chlorine at every point of consumption is not economically feasible, hydraulic and water quality models are used to estimate chlorine concentrations. EPANET is an industry-standard software for such simulations. However, when applied to highly detailed networks or if it isn’t configured properly, it can produce inaccurate results, due to mass propagation, sample delay, and discretization errors. This work studies the numerical behavior of chlorine transport and decay simulations in EPANET, with a focus on identifying the conditions under which simulation results deviate from the correct solution. The main objective is to determine how the choice of simulation parameters, especially the water quality time step and network discretization, affects accuracy, and to propose a practical methodology for selecting optimal parameters that balance precision and computational efficiency. Controlled experiments using simplified network models are run. These initial tests demonstrate the effects of concentration propagation and residence time violations when the quality time step exceeded pipe residence times. A mass balance analysis demonstrates that, despite these inaccuracies, EPANET conserves mass. Additionally, when it came to decay, it was found that the discretization error was negligible, since the rate of decay was very slow in comparison to the used time step (as low as a 0.5% error using a 30 minute step). The methodology is then applied to a real drinking water distribution network corresponding to the Can Colomer sector in Terrassa, Spain. Three different network discretizations and three demand scenarios are tested, resulting in nine simulation cases. Hydraulic residence time distributions are computed and compared with simulation errors obtained at varying time steps, using multiple accuracy indicators, including chlorine concentration error and accumulated chlorine mass error. The results show some relationship between the minimum pipe residence times and the maximum admissible quality time step, depending on the indicator used. Based on accuracy constraints, practical thresholds are established to select time steps that ensure reliable chlorine predictions. After comparing the results for each indicator, it is found that the root mean square error of the chlorine ppm’s at all nodes over time is better for most cases. Finally, a software program is presented to automatically select the optimum time step for a given network model

Fields of Study & Subjects

Water Systems and Optimization Water Treatment and Disinfection Urban Stormwater Management Solutions

Publication details

Journal / source
UPCommons institutional repository (Universitat Politècnica de Catalunya)
Publication date
5 February 2026
Language
EN
Document type
Thesis