Dynamic Modelling of Hydrogen Transmission Pipelines : Assessment of Durability and Effect of Storages

Summarise with VIRAT
Authors: Janne Jauhola
Cited by: 0

Summary

No summary yet. VIRAT can read this paper and write a plain-language summary of its aim, methods, key findings and limitations.

Summarise with VIRAT Free to try with your Science Catalogs account.

Abstract

This master’s thesis examines, at a system level, what kind of hydrogen transmission network could emerge in Finland and provides a structural durability assessment for such a network. The objective was to identify the factors influencing durability and to evaluate whether the pipeline material meets its intended service life. In addition, the impact of hydrogen storage on system durability and usability was investigated. Electrolytic hydrogen production based on renewable energy sources leads to pressure fluctuations in pipelines, which challenge material durability. These fluctuations can cause fatigue, accelerated by hydrogen embrittlement. Storage can help reduce pressure variations. The initial part of the work reviewed future scenarios, hydrogen production methods, and identified different consumer types and their flexibility. The theoretical basis for hydrogen transmission in pipelines was established through fluid mechanics, material properties, fracture mechanics, and fatigue theory. Flow modelling is based on continuity, momentum, and energy equations. Based on the selected future scenario, a dynamic model was developed using the Simone software for network simulation. The model represents a simplified example of planned Finland’s backbone network, including five hydrogen valleys where hydrogen is produced and consumed. The hydrogen production profile was created using wind and solar generation statistics from 2024. Three annual consumption scenarios were developed: inflexible, fully flexible, and one including storage. The simulation produced pressure fluctuation spectra for the entire year at different pipe-line locations under all three scenarios. The structural assessment examined the properties of materials suitable for hydrogen trans-mission and the depth of manufacturing defects that act as crack initiation points. Two standardised fatigue crack growth rate (FCGR) models (ASME B31.12 and IGEM) were compared for fatigue assessment, and a Failure Assessment Diagram (FAD) was used for fracture evaluation. Material selection was outside the scope of this thesis; therefore, a medium-strength steel grade X52 / L360, widely used and well-studied, was chosen for analysis. The pressure fluctuation spectrum was used as input for fracture mechanics and fatigue models, with stress cycles calculated using the Rainflow method. A crack growth and fracture assessment model was developed in MATLAB. The analysis included multiple cases, resulting in calculated service lives for all scenarios. The results showed that the factors influencing service life, in order of importance, are initial crack depth, magnitude of pressure fluctuations, selected crack growth calculation method, use of storage, consumer flexibility, and pipe wall thickness. Initial crack depth proved to be the most critical factor, controllable during manufacturing and inspection. Its impact on service life ranged from 100% to 670%. The pipeline meets the 50-year service life target if quality requirements are fulfilled without operational restrictions. The IGEM standard was more conservative than ASME, reducing service life below 50 years for deep cracks. Storage improved service life by up to 82% but requires very large storage capacity. This work provides new insights for the design of future hydrogen systems and addresses a research gap between pressure fluctuations caused by renewable production and material durability. The results can support investment decisions and risk management in the emerging hydro-gen economy.

Fields of Study & Subjects

Material Properties and Failure Mechanisms Structural Integrity and Reliability Analysis Hydrogen embrittlement and corrosion behaviors in metals

Publication details

Journal / source
Tampere University Institutional Repository (Tampere University)
Publication date
1 January 2026
Language
EN
Document type
Thesis