Abstract
This thesis focuses on the interaction between a plasma and a water surface. When a high electric potential is applied to a needle electrode positioned above a water reservoir with a submerged grounded electrode, an electric breakdown (a plasma) occurs in the gap between the pin electrode and the water surface. Reactive chemical species that are created by this gaseous breakdown result in interesting and complex chemistry, not only in the gas phase, but between gas and liquid as well. At the surface layer of the water, fast reactions take place. However, only long-lived species make their way to the bulk of the water. Three of these long-lived species that appear in this plasma-treated water (PTW) are NO2-, NO3- and H2O2, giving the water nutritious and disinfecting properties. These properties make PTW suitable for applications in the biomedical and agricultural fields. The characteristics and behavior of this gas discharge are strongly affected by the properties of the liquid medium. At very short timescales, the generated plasma behaves as a dielectric barrier discharge (DBD), where the water prevents the conduction of electrical charges from the surface to the submerged electrode. Instead, charges accumulate on the water surface, which cause an electrical field opposite to the field in the gap, prohibiting the formation of the plasma. Applying an alternating potential (AC or high-voltage pulses) allows to reignite the plasma in the discharge gap (and is needed for typical DBDs to operate). At relatively longer timescales, electrolysis between the surface charges and the submerged electrode can take place where the liquid serves as a (badly) conducting barrier instead. This affects the accumulating electrical charges at the surface and makes it possible to form a plasma in the gap (contrary to the DBD behavior), creating an electrically conducting path between the electrodes. The length of these time scales depends on the conductivity of the liquid medium, which changes over time during the PTW process, and as such, both regimes are observed in the experiments. This thesis provides a study where properties of plasma and water are investigated in this discharge system. As the properties of the water change in time, so do the dynamics of the discharge. This interdependence of plasma and water properties is examined and is visible throughout the results. Information on the power dissipation and electrical charge deposition are obtained by measuring the voltage and current signals of the electric discharge. In the electrolytic regime, an increasing current is measured as the conductivity increases. In addition, by correlating the total dissipated power to the concentration of NOx- species in the water, a linear relation is found. Imaging the discharge with an ICCD camera allowed observation of the morphologic development of the discharge on a nanosecond scale. Here, a clear difference between the 'DBD-like' and 'electrolytic' regime is observed throughout the measurements. With optical emission spectroscopy with a high spectral resolution, line structures of the emission from species in the plasma are investigated. The emission of nitrogen molecules is observed to obtain the gas temperature during the discharge events, varying from close to room temperature to a few thousand kelvin. Furthermore, the broadening of emission lines of hydrogen atoms H_α and H_β is studied to determine the electron density in the discharge gap. Under conditions where there is sufficient emission from the two investigated lines, comparable densities are obtained from the different hydrogen lines, which are in the order of 10^21 m^-3 electrons, showing consistency within this method. In addition to the discharge properties, the pH value and conductivity of the water are documented after plasma treatment, which are used to estimate values for the concentration of NOx- species in the water. To study the effect of pulse parameters on the discharge and the PTW process, different operation modes are compared. In the first experiments, a plasma is created using short positive or negative unipolar high voltage pulses, or an AC high voltage waveform. To extend the research on the effect of pulse parameters, experiments performed later in the project used a custom-made pulse generator (designed by Jeroen van Oirschot), which allowed for a much more flexible design on the input parameters of the applied voltage.